Upgrading The Fdap Firmware - Honeywell ControlEdge 900R04-0200 Getting Started

a. On the Selection Panel, select the field device.
b. On the Property Panel, expand
c. Under
Identification

Upgrading the FDAP firmware

1. On the Selection Panel, select the target FDAP. You can select
multiple devices of the same type using the Selection Panel. Click
and hold SHIFT key on the keyboard and select multiple items in a
successive list. Click and hold CTRL key on the keyboard and
select multiple items not in succession.
2. Click in the
Radio
Firmware Upgrade
3. In the
Available Firmware Files
upgrade file. The firmware upgrade file should appear in the list by
default. If the file is not available in the list, perform the following
steps to open the firmware file.
a. Click to browse to the directory location of the firmware
Add
upgrade file.
b. Select the target firmware upgrade file, and click
Firmware files are stored in volatile memory due to memory
limitations in the controller. Hence these files will be removed on
power cycle.
4. Click . The
Upgrade
Progress column displays the progress of the upgrade.
See the following tips for other operations:
To abort any firmware upgrade operation, click the
l
icon besides the upgrade status.
Upgrade
To remove the devices whose firmware was upgraded
l
successfully, click the
status.
The field device will be rebooted after the field device radio
l
firmware upgraded successfully.
5. Close the
Firmware Upgrade Status
6. Verify the upgraded version of the FDAP firmware as follows:
Device Manager Summary
, check
Revision
group from the Ribbon Bar. The
Upgrade
dialog box appears.
list, select the required firmware
Firmware Upgrade Status
Clear Upgrade
dialog box.
Chapter 5 - Operating
.
.
Open
dialog box appears. The
Abort
icon besides the upgrade
.
Radio
81