Configuring Controller Start Up - Honeywell ControlEdge 900R04-0200 Getting Started

Port Default setting
The secondary controller static IP address: 192.168.1.51
To configure IP address
1.
2.
3.
4.
5.
TIP: If new IP settings are compiled and downloaded, the
controller will be disconnected from the configuring device.

Configuring controller start up

This function enables you to configure the controller status after the
power cycle.
For ControlEdge 900 controller, this feature is only applicable when
the mode switch is in REMOTE position.
Under
the
for controller start up:
n
From the Home Page, click the arrow beside
, and select
Ports ETH1
Under
Network Setting
port for the controller.
Under the
Protocol Binding
bind to the port.
Click to complete the Ethernet port configuration.
Save
Click to return to the Home Page.
Back
Controller and Programming
Configure Controller Start Up
Last operating mode, or Running after an abnormal stop
This option is the default setting for ControlEdge 2020 controller.
The controller will start in the operating mode that it was last in
prior to a power off, unless there was an abnormal stop caused by
a system error such as a watchdog timeout issue. It will then start
in Running mode.
If the controller was in Running mode before power off, the
l
controller will warm start in Running. If the warm start fails, the
controller will go to Stopped mode.
If the controller was stopped manually before power off, the
l
controller will start in Stopped mode.
If the controller was stopped abnormally before power off, the
l
or .
ETH2
, configure the IP address of the Ethernet
, select the protocol which you want to
, select
Configure Controller Start Up
page appears. There are four options
Chapter 4 - Software
Configure Ethernet
,
45