Honeywell ControlEdge 900R04-0200 Getting Started page 80

Chapter 5 - Operating
80
TIP: It is recommended to select and accept up to three
devices at a time.
2. Click one of the following icons as required in the
from the Ribbon Bar. Application firmware must be upgraded
before upgrading the radio firmware.
: To upgrade the application firmware of the selected
Application
l
field device.
: To upgrade the radio firmware of the selected field
Radio
l
device.
The
Application/Radio Firmware Upgrade
3. Depending on the firmware type, the available upgrade files
appear by default. Select the required file from the list of upgrade
files. If the file is not available in the list, perform the following
steps.
a. Click to browse to the directory location of the firmware
Add
upgrade file.
b. Select the target firmware upgrade file, and click
4. Click . The
Upgrade
closes. The
Firmware Upgrade Status
status of the upgrade appears. Closing the dialog box allows the
upgrade operation to run in the background.
Once the upgrade is complete, the status column displays the
status as complete. If firmware upgrade fails for a device, you can
abort the upgrade and start again. To abort firmware upgrade for
individual devices, click the abort button next to the status
indicator.
See the following tips for other operations:
To abort any firmware upgrade operation, click the
l
icon besides the upgrade status.
Upgrade
To remove the devices whose firmware was upgraded
l
successfully, click the
status.
The field device will be rebooted after the field device radio
l
firmware upgraded successfully.
5. Close the
Firmware Upgrade Status
6. Verify the upgraded version of the field device firmware as follows:
Application/Radio Firmware Upgrade
dialog box displaying the
Clear Upgrade
dialog box.
Upgrade
dialog box appears.
.
Open
dialog box
Abort
icon besides the upgrade
group