SERVICE MANUAL
Warning
• Dangerous Voltage
• Possible damage from electrostatic discharge
[6] If the developer temperature is not correct:
(a) Remove the DRIVE SIDE PANEL.
(b) Open the DOOR on the ELECTRICAL BOX.
(c) Use the POTENTIOMETER ADJUSTING TOOL TL-1481 to adjust R2 on the 100 CIRCUIT BOARD:
• Rotate R2 clockwise to increase the temperature
• Rotate R2 counterclockwise to decrease the temperature
[7] Allow the developer solution to reach a stable temperature.
[8] Do Step 4.
[9] Close the DOOR on the ELECTRICAL BOX.
[10] Install the DRIVE SIDE PANEL and TOP COVER.
30
12JAN99 – 7C8772