Lubrication Procedure And Schedule - Kodak X-Omat 2000 Service Manual

Lubrication Procedure and Schedule

Warning
Dangerous Voltage
[1] Disconnect the main power before applying lubrication to the PROCESSOR.
Caution
Do not allow lubricants to touch the CROSSOVERS or RACK ASSEMBLIES, or to drip into the TANKS.
[2] Apply lubricant to the parts identified in the Table:
Part
MAIN DRIVE CHAIN
RECIRCULATION
PUMPS
DRYER BLOWER
BEARINGS
MAIN DRIVE MOTOR
GEAR HOUSING of the
MAIN DRIVE MOTOR
7C8772 – 12JAN99
Frequency of
Lubrication
As necessary, NLGI - No. 2 LITHIUM BALL
check monthly AND ROLLER BEARING
GREASE TL-2324
Every 6 months LIGHT OIL
Example: SAE No. 20 MOTOR
OIL TL-2244
Every 6 months LIGHT OIL
Example: SAE No. 20 MOTOR
OIL TL-2244
No lubrication is necessary
No lubrication is necessary
Lubricant
Apply to the surface of the
CHAIN.
Apply drops of OIL in the
OIL HOLES.
Apply drops of OIL in the
OIL HOLES.
Periodic Maintenance
Procedure
53