Installing A New B Roller - Kodak X-Omat 2000 Service Manual

SERVICE MANUAL
[1] Remove:
• EXIT GUIDE SHOE and 2 BRACKETS
• ROLLER above the GUIDE SHOE
• 2 SPRINGS and LOCKING PLATE
• 2 A ROLLERS
[2] Pull the SHAFT from the B ROLLER from the non-drive side.
[3] Remove:
• 4 HOLDING SCREWS
• CHAIN from the B ROLLER
• TURNAROUND AY

Installing a new B ROLLER

See the Figure on Page 17.
[1] Remove:
• TURNOVER AY from the RACK
• 2 SPRINGS
• LOCKING PLATE
• 2 A ROLLERS
• 2 SCREWS
• 2 BRACKETS
• EXIT GUIDE SHOE
• SHAFT, THRUST WASHERS and the BEARING from the B ROLLER
[2] Install:
• new B ROLLER, THRUST WASHERS and the BEARING on the SHAFT
• EXIT GUIDE SHOE
• 2 BRACKETS
• 2 SCREWS
• 2 A ROLLERS
• LOCKING PLATE
• 2 SPRINGS
• TURNOVER AY in the RACK
[3] Use the procedure on Page 10 to adjust the tension on the DRIVE CHAIN, if necessary.
18 12JAN99 – 7C8772