Installing A New Guide Shoe - Kodak X-Omat 2000 Service Manual

SERVICE MANUAL
[3] Loosen the 4 NUTS on the TIE RODS.
[4] Press down on the SIDE PLATES so that the SIDE PLATES make uniform contact with the flat surface.
[5] Tighten the 4 NUTS.

Installing a new GUIDE SHOE

LONG
TIP
8
GUIDE SHOE
SHORT
TIP
H172_1045CCA
H172_1045CA
[1] Remove:
• SCREWS
• GUIDE SHOE
[2] Install the new GUIDE SHOE with the LONG
TIPS in the direction of film transport.
[3] Install the SCREWS.
Note
There are no adjustment procedures for GUIDE
SHOES.
12JAN99 – 7C8772