Rack Adjustments; Adjustment For Squareness - Kodak X-Omat 2000 Service Manual

RACK Adjustments

Adjustment for Squareness

Purpose: Use this procedure for the DEVELOPER, FIXER and WASH RACKS.
To adjust the squareness of a DRYER RACK, use the procedure on Page 14.
smooth, flat surface
SIDE PLATE
H172_1040ACA
H172_1040AC
7C8772 – 12JAN99
H172_1039AA
TIE ROD
SIDE PLATE
6 SCREWS
Adjustments and Replacements
[1] Remove the RACK from the PROCESSOR.
[2] Place the RACK on a smooth, flat surface.
[3] Loosen the 6 SCREWS on the TIE RODS.
[4] Check that the SIDE PLATES are flat on the flat
surface.
[5] If necessary, apply pressure to the SIDE PLATES.
See the figure.
[6] Tighten the SCREWS.
9