Table of Contents
Advertisement
6.
Plug one end of a Category 5, 6, or 6E network crossover cable into the Ethernet (LAN)
connector on the PC1 rear panel (see
page 8 for information on wiring the RJ-45 LAN connector). Plug the other end of
the Ethernet cable into the Ethernet port on the computer.
NOTE: If you are using a network hub or switch between the computer and the
PC1, use a straight-through Category 5 cable instead of a crossover cable.
7.
Set up the PC1 IP address (see
for the procedure).
Once the PC1 has been reconfigured, you can subsequently use an Ethernet (intranet
or Internet) connection to configure or control it.
NOTE: Both your computer and the PC1 must be connected to the same LAN.
Configuring the IPL T PC1 Using a Web Browser
The default web pages that are preloaded on the PC1 are compatible with popular web
browsers such as Internet Explorer (version 5.5 or higher).
NOTE: The following instructions assume that you have configured the Windows-based
computer, connected it to the PC1 LAN port, and powered on the interface.
1.
Obtain a valid IP address, subnet mask, and gateway address for the PC1 from your
network administrator.
2.
Launch a web browser (such as Internet Explorer) on the connected computer (for
which you set up the network configuration earlier), and enter the default address of the
PC1,
http://192.168.254.254
displayed.
3.
Select the
on the left of the screen. The PC1 System Settings page appears, showing the default
IP address.
Configuring the IPL T PC1 Using a Web Browser
, in the address box. The PC1 default web page is
tab, then select
Configuration
IPL T PC1 • HTML Configuration and Control
Wiring the Local Area Network (LAN) Port
from the sidebar menu
System Settings
on
20
Advertisement
Table of Contents
