Extron electronics IP Link Series User Manual page 68

Command
Reset (Zap) and Erase Commands
NOTE:
None of the following zap commands (ZFFF, ZXXX, ZY, or ZQQQ) reset the AC power receptacle. Power remains in its
current state.
Erase all files from user flash
memory
24
Reset all device settings to factory
default
24
NOTE: This reset is product-dependent. It resets receptacle name and lock mode to Off. It does not reset IP settings such as IP
address, subnet mask, gateway IP address, and IP security level table; and it does not remove the user file system.
Absolute system reset; retain IP
address
NOTE: This reset is the same as ZQQQ (below), except that it excludes IP settings such as IP address, subnet mask, gateway IP
address, unit name, DHCP, and port mapping (Telnet, web, and Direct Access) in order to preserve communication with the device.
It also erases the user file system. This reset is recommended to be used after a firmware update.
Absolute system reset
24
NOTE:
•
This is a mode 5 reset (see
version remains the same.
•
The factory configured passwords for all accounts on this device have been set to the device serial number. In the event of a
complete reset to factory defaults, the passwords revert to the default, which is no password for the device.
ASCII (Telnet)
(Host to Switcher)
E ZFFF }
E ZXXX }
E ZY }
E ZQQQ }
Resetting on page 12). It resets all device settings to the factory defaults; however, the firmware
URL Encoded (web)
(Host to Switcher)
W ZFFF |
W ZXXX |
W ZY |
W ZQQQ |
IPL T PC1 • SIS Programming and Control
Response
(Switcher to Host)
Zpf ]
Zpx ]
Zpy ]
Zpq ]
60