Table of Contents
Advertisement
Troubleshooting
Turn on the equipment in the following order:
1.
2.
3.
If the output AV device cannot be powered on, check the following:
Power Connections
1.
2.
Network Connections
1.
2.
The PC1 power control interface
The power receptacles on the PC1
The connected output device on the AC receptacle.
Make sure that the output receptacle is receiving power. The green Power LED on
receptacle remains lit steadily while the receptacle has power. If necessary, press the
receptacle
button to apply power.
Power
Ensure that the device is plugged in properly to the rear panel of the PC1 and switched
on if applicable.
Check the network connections and make adjustments as needed. The green Link
LED lights steadily while a network connection is detected. The yellow ACT LED blinks
if there is activity on the network. If these LEDs are not lit, either the cable is faulty or
not plugged in, or the wrong type of cable is being used (see
page 6).
At the DOS command prompt, try to ping the unit by entering
assigned to your PC1 (see
page 15 ). If the PC1 is connected and communicating, you receive the following
response to your ping command:
Figure 40.
Successful Ping Command Response
Setting Up and Configuring the PC1 Using ARP
IPL T PC1 • HTML Configuration and Control
Connecting Cables
on
and the IP address
ping
on
45
Advertisement
Table of Contents
