Configuring The Ipl T Series With Global Configurator - Extron electronics IPL T S1 Setup Manual

5. Execute a ping command by typing ping followed by a space and
the new IP address at the command prompt. For example:
ping 10.13.170.15
After issuing this command, the controller changes to the new
address and starts responding to the ping requests, as described.
You must ping the IPL T controller in order for the IP address
change to take place.
Figure 15.
You can reconnect using either Telnet or a Web browser to verify
that the update was successful.
6. After verifying that the change was successful, enter and issue the
Arp -d command at the command prompt. For example:
arp -d 10.13.170.15 removes the 10.13.170.15 from the ARP
table
- or -
arp -d* removes all static IP addresses from the ARP table.

Configuring the IPL T Series with Global Configurator

After you have installed the Global Configurator (GC) software on the
PC and downloaded device drivers, do the following:
1. Create a GC project file.
2. Configure the IPL T Series controller and other devices.
3. Launch the GlobalViewer
4.
Test the configuration and the system.
Refer to the Global Configurator Help file for these procedures.
The Global Configurator Help file includes an introduction to the
software and a section on how to start a Global Configurator project.
It also features step-by-step instructions on the basic tasks involved in
configuring an IPL T controller.
If you have questions during installation and setup, you can call the
Extron S3 Sales & Technical Support Hotline or the Extron S3 Control
Systems Support Hotline.
20 IPL T Series • Setup
Controller Response to a Ping Request
interface.
®