Extron electronics IP Link Series User Manual page 52

3. At the prompt, enter the IP address of the PC1 unit (the default IP address is
< to >
. If the address was changed in the setup or configuration process,
192.168.254.254
use the new address). Telnet defaults to port 23.
Figure 38. Connecting to the IP Address
4. If new passwords were set up for the connected system, you are prompted to log in as
an administrator or a user. Otherwise, the system responds with a carriage return and
line feed ( ).
<CR/LF
NOTE: The factory configured passwords for all accounts on this device have been
set to the device serial number. In the event of a complete reset to factory defaults,
the passwords convert to the default, which is no password (see
Passwords on page 29 to change a password).
Figure 39. Connection Response
5. Once you are connected, you can enter SIS commands as desired; for example,
(power on) or (power off) (see
1*0PC
more information on entering SIS commands.
6. When you are finished entering commands to the interface, enter
command prompt to exit Telnet.
Receptacle
Power Button
SIS Programming and Control
IPL T PC1 • HTML Configuration and Control
POWER
I
Receptacle
Power LED
Assigning
1*1PC
on page 47 for
at the
Ctrl+]
44