Extron electronics IP Link Series User Manual page 35

RS-232 port
1. From the drop-boxes in the RS-232 port type section (left column), select the baud
rate, data bits, parity, stop bits, and flow control for the PC1 serial COM port.
2. Click to enter your selections.
Submit
If you click before submitting your selections, your entries are reset to the last
Cancel
saved parameters.
Defaults are:
Baud Rate:
9600
Data Bits:
8
Parity:
None
Stop Bits:
1
Flow control:
None
Contact input port
This section (right column) shows the status of the contact input port. If
the contact is closed (connected to ground). If
connected to ground).
NOTE: You cannot make changes in this field; it only reflects the condition of the port.
AC receptacle
In the
AC Receptacle Settings
Enter a name for the receptacle, which could reflect the output device connected to
•
it, the room in which the device is located, and so forth. The name can be 1 to 12
characters. The following characters are not permitted:
# % + = ~ ` : ; " ' , . | \
By default, the receptacle is named
• Select the or radio button to power the connected device on or off.
On Off
Click to implement your changes. If you click
Submit
selections, your entries are reset to the last saved parameters.
is selected, the contact is open (not
Off
section, you can do the following:
.
Receptacle 1
Cancel
IPL T PC1 • HTML Configuration and Control
is selected,
On
before submitting your
27