Extron electronics IP Link Series User Manual page 37

Assigning passwords
The screen allows you to assign passwords to the administrator and user
Passwords
access levels.
NOTE: The factory configured passwords for all accounts on this device have been set
to the device serial number. In the event of a complete reset to factory defaults, the
passwords convert to the default, which is no password.
The administrator password gives access to all IPL T PC1 web pages, enabling the
administrator to configure the PC1.
The user password provides access only to the
in as user, you see only the
any configuration changes.
To assign passwords:
1. On the
Configuration
2. Enter the new administrator password in the
Passwords must contain 4 to 12 alphanumeric characters.
Spaces and non-alphanumeric symbols are not allowed, and the passwords are case
sensitive.
3. In the
Re-enter Admin Password
Figure 22. Passwords Page with Administrator and User Passwords Entered
4. If you want to assign a user password, enter it in the
NOTE: You cannot assign a user password unless an administrator password has
either been assigned or is being assigned at the same time.
5. Reenter the same user password in the
6.
Click to set the passwords.
Submit
Removing passwords
To remove a password:
1. On the
Configuration
2. In the
Administrator Password
are there, and press the <
System Status
tab with the
Status System Status
page, select from the sidebar menu.
Passwords
Administrator Password
field, enter the same password again to confirm it.
Re-enter User Password
page, select from the sidebar menu.
Passwords
or the
User Password
> to enter a space.
Spacebar
IPL T PC1 • HTML Configuration and Control
web page. If you are logged
page. You cannot make
field.
field.
User Password
field.
field, delete the characters that
29