Mode 4; Mode 5 - Extron electronics IP Link Series User Manual

Mode 4

Activation
Result:
Purpose and notes Mode 4 enables you to set IP address information using ARP and

Mode 5

Activation:
Result:
Purpose and notes Mode 5 is useful if you want to start over with control software
NOTE: The factory configured passwords for all accounts on this device have been set
to the device serial number. In the event of a complete reset to factory defaults, the
passwords convert to the default, which is no password (see
on page 29 to change a password).
Hold the button in until the Power LED blinks twice
Reset
(approximately 6 seconds). Release it, then immediately press it
again momentarily (for less than 1 second). The Power LED blinks
four times in quick succession, confirming a mode 4 reset.
NOTE: Nothing happens if the momentary press does not
occur within 1 second.
Reset mode 4 does the following:
Enables ARP program capability.
•
• Sets the IP address back to factory IP settings.
• Sets the subnet mask back to factory default.
• Sets the gateway address back to factory default.
• Sets port mapping back to factory default.
Turns DHCP off.
•
• Turns events off.
the MAC address.
Hold in the button until the Power LED blinks three times
Reset
(approximately 9 seconds). Release it, then immediately press it
again momentarily (for less than 1 second). The power LED blinks
four times in quick succession, confirming a mode 5 reset.
NOTE: Nothing happens if the momentary press does not
occur within 1 second.
Performs a complete reset to factory defaults (except for the
firmware).
configuration and to replace events.
IPL T PC1 • Front Panel Features and Operation
Assigning Passwords
14