Extron electronics IP Link Series User Manual page 65

Command
IP Setup Commands (continued)
Set broadcast port and MAC
address
View broadcast port and MAC
address
Port number is the UDP outgoing port.
NOTE:
Get connection listing
X1*
KEY: = Hardware (MAC) address (xx-xx-xx-xx-xx-xx).
X7!
= Hardware (MAC) address: the four most significant hex nibbles converted into a single 16-bit decimal number.
X7@
= Hardware (MAC) address: the eight least significant hex nibbles converted into a single 32-bit decimal number
(this can be up to 10 digits).
Password and Security Settings
NOTE: The factory configured passwords for all accounts on this device have been set to the device serial number. In the event of a
complete reset to factory defaults, the passwords convert to the default, which is no password.
Set administrator password
24
Clear administrator password
24
NOTE: A user password cannot be assigned if an administrator password does not exist. If the administrator password is cleared
(removed), the user password is also removed.
View administrator password
24
Set user password
14, 24
Clear user password
24
View user password
24
Query session security level
NOTES:
•
The ] Password prompt requires a password (administrator level or user level), followed by a carriage return. The password
prompt appears only if there is a password defined on the unit.
•
The copyright information shown on connection to the IP Link product via TCP/IP or Telnet is followed by the password prompt.
•
The ] Password prompt is repeated if a correct administrator or user password is not entered.
•
If a correct administrator or user password is entered, the unit responds with
User ] , depending on the password that was entered. If the administrator and user passwords are the same, it defaults to
administrator privileges.
X3#
KEY: = Password (minimum length = 4 characters; maximum length = 12 characters. No special characters are allowed.
X4!
= Reading password. Responds with four asterisks (****) in place of the password, if a password exists.
Responds with an empty space if no password exists.
X5@
= Connection security level
Directory Commands
Change or create a directory
A directory does not truly exist until a file has been copied into the path.
NOTE:
Move back to root directory
Move up one directory
View current directory
ASCII (Telnet)
(Host to Switcher)
E port number* X7! * X7@ PB
E PB }
X7! * X7@ is the MAC address for UDP unicast transmissions.
E CC }
Verbose modes 2 and 3
E X3# CA }
E• CA }
E CA }
E X3# CU }
E• CU }
E CU }
E CK }
Verbose modes 2 and 3
11 = user, 12 = administrator
E path/directory/CJ }
E /CJ }
E ..CJ }
E CJ }
URL Encoded (web)
(Host to Switcher)
}
W port number* X7! * X7@ PB |
W PB|
W CC |
W X3# CA |
W %20 CA |
W CA |
W X3# CU |
W %20 CU |
W CU |
W CK |
] Login Administrator
W path/directory/CJ |
W %2F CJ |
W %2E %2E CJ |
W CJ |
IPL T PC1 • SIS Programming and Control
Response
(Switcher to Host)
Bpt port number* X1* ]
port number* X1* ]
Number of connections ]
Icc Number of connections
Ipa• X4! ]
Ipa• ]
X4! ]
Ipu• X4! ]
Ipu• ]
X4! ]
X5@ ]
Pvl X5@ ]
] or ] Login
Dir • path/directory/ ]
Dir • / ]
Dir • path/directory/ ]
path/directory/ ]
]
57