Configuring The New Drive - Extron electronics VNR 100 User Manual

1. Switch the recorder off
by pressing and holding
down the power switch
(figure 14,
( ) flash red and then go
B
out.
2. Unplug the recorder.
3. Press the red catch. The
lever arm is released (see the
figure to the right).
4.
Swing the lever arm out until
it is perpendicular to the front
of the drive caddy (as shown
in the figure to the right). Use
the arm to pull the caddy out
of the drive bay.
5. Remove the drive. There are
no screws to be removed or
cable connections to be undone.
6. Insert the new drive into the drive bay.
7. Push the caddy back into the recorder.
8. Swing the lever arm back until it clicks into place behind the catch.
ATTENTION:
ATTENTION:

Configuring the New Drive

1. Attach a mouse to the rear panel PS/2 mouse port
( ) and a keyboard to the rear panel PS/2 keyboard
E
port (
F
and keyboard to the front panel USB ports (see
figure
USB ports (
2. Connect a VGA monitor to the rear panel port (
3. Power on the recorder by pressing the front panel
power switch ( see
4. Power on the monitor. The login screen
is displayed.
5. Enter the
NOTE: By default, the
matrix_rec
matrix
) until the LEDs
A
Do not power on the unit at this time.
Ne branchez pas l'unité à ce moment là.
). Alternatively, you may connect the mouse
15, on the previous page) or the rear panel
C
in the figure to the right).
D
figure 15, ).
A
and
Username Password
Username
and the
Password
.
A
).
G
.
is
is
VNR 100 • Replacing the VNR 100 Drives
B D
C D E F G
16
H