Inf. Mx/Mn; Squelch; Changing Display Settings (Display And Tone); Changing Display Settings - L3Harris Narda SignalShark User Manual

Inf. Mx/Mn

Tap the Inf. Mx/Mn button to switch between On and Off.

Squelch

To set the Squelch value:
1. Tap the Squelch button.
2. Enter the required value and select a unit.
The setting is accepted immediately and the menu is closed.

Changing display settings (Display and Tone)

Here you can change general display settings such as the zero point of the Y-axis, the range
of the Y-axis or the axis unit (the available settings depend on the current view). In the lower
section of the Button bar you can enable tone search and change the tone search
configuration.
To open the menu:
You selected the Level Meter view.
1. Tap the Display and Tone button.
The menu opens.
2. You can now do the following

Changing display settings

Lmax
Here you can do the following:
• Set the zero level of the y-axis
• Set the Entry Mode: Absolute or Relative
• Set the Coupling: On / Off (not available in Level Meter view)
When coupling is set to On, the views of a task are coupled (e.g. the axis).
To set the zero level:
1. Tap the Lmax button.
2. Enter the required value and tap the unit button.
The setting is accepted immediately and the input window is closed.
3. Press the Esc key to close the menu.
Settings in the Lmax context menu
Long tap the Lmax button.
The context menu opens.
Entry Mode
The Entry Mode button allows you to determine whether values are entered as absolute or
relative values.
To set the Entry Mode:
Level Meter View
99