Step 1 - Selecting A Scan Type (Scan Type); Step 2 - Changing Measurement Settings; Step 2 - Changing The Measurement Settings (Change Settings) - L3Harris Narda SignalShark User Manual

Step 1 – Select a scan type
Step 2 – Change measurement settings
Step 3 – Running a horizontal scan
Step 4 – Saving bearing results
Step 1 – Selecting a scan type (Scan Type)
Following scan types are available:
• Continuous: After starting, the system continuously adds level measurements together
with their compass values to the current scan and calculates a bearing result.
• Discrete: After starting, the user can add discrete level measurements together with their
compass values to the current scan. The system calculates a bearing result with each
new value.
• Discrete with Max Hold: Same as discrete scan type but only max. power level is added
to the scan.
The measurement behavior and the menu structure depends on this setting. In most cases
the default value Continuous will fit.
To select a scan type:
Tap the Scan Type button and select a type from the dropdown list:
Next step:
See

Step 2 - Changing measurement settings

Step 2 - Changing measurement settings
Step 2 – Changing the measurement settings (Change
Settings)
Here you adapt, among other parameters, the tuning frequency and the channel bandwidth
to the signal of interest.
Horizontal Scan
161