Table of Contents
Advertisement
Horizontal Scan
Horizontal Scan
Horizontal Scan plots the signal strength versus the angle of incidence on a polar diagram.
The measured signals are normalized to the maximum value linearly during the
measurement (1 = 100 % signal strength). The display allows you to more easily see the
difference between the received signal and the reflections that occur. The SignalShark
automatically calculates the bearing of the signal source based on the horizontally measured
values.
The calculation of the main angle of incidence is performed where possible using a quadratic
regression of the measured values obtained. Otherwise, the azimuth angle of the maximum
level is assumed to be the direction of transmission and a message to this effect is displayed.
General operating steps
Following step may help you to successfully run a horizontal scan:
159
Advertisement
Table of Contents
