Running A Discrete With Max Hold Horizontal Scan; Restarting The Measurement; Resetting The Measured Maximum Power Level; Manually Correcting A Result - L3Harris Narda SignalShark User Manual

Running a Discrete with Max Hold horizontal scan

1. Tap the Scan Type button and select Discrete with Max Hold from the dropdown list.
2. Press the key on the handle to start the measurement.
3. Turn around and wait for the maximum power level.
Watch the spirit level and make sure that the antenna is properly oriented, both
horizontally and vertically.
4. Press the key on the handle twice: The first press resets the max hold of the previous
value, the second adds the new value. Add further values in the same way.
5. Long press the key on the handle to stop the measurement.

Restarting the measurement

Tap the Restart button

Resetting the measured maximum power level

The maximum power level is represented by the orange line in the power level bar.
Tap the Reset Max button.

Manually correcting a result

Sometimes it may be necessary to manually correct the calculated result (e.g. due to
reflections).
To correct a calculated result:
You stopped the scan.
1. Point the antenna to the wanted direction.
2. Tap the Manual Correction button.
The result is replaced by the current antenna direction.
The button now shows Calculated Result.
3. To recall the calculated result tap the Calculated Result button.
Again the calculated result is displayed.

Resetting a calculated result

Tap the Reset button.
The results in the polar chart and in the Calculated column are deleted.
You may now start a new scan.
Next step

Step 4 - Saving bearing results

Step 4 – Saving bearing results
You stopped the scan.
Long press the antenna handle key or press the Save button on the device.
Horizontal Scan
171