Table of Contents
Advertisement
To change these parameters:
1. Tap the toggle button to select Hold or Stop.
2. Press the Esc key or tap the header to close the menu.
Setting the detectors (Detector)
To select the detector type:
1. Tap the Detector button and select a type from the dropdown list.
2. Press the X button to close the dropdown list.
Changing the general display and tone settings (Display
and Tone)
Here you can change general display and tone settings such as the zero point of the Y-axis,
the range of the Y-axis or the axis unit (the available settings depend on the current view).
Lmax
Here you can do the following:
• Set the maximum power level of the graph
• Set the Ref.L. -> Lmax function On or Off
• Select Default Range
• Select the Unit
To set the maximum power level:
1. Tap the Lmax button.
2. Enter the required value and tap the unit button.
The setting is accepted immediately and the input window is closed.
3. Press the Esc key to close the menu.
To select the Unit:
1. Tap the Unit button.
The Unit dropdown menu opens.
2. Select one of the units (dBm, dBV, dBmV, dBuV) and close the menu by tapping the x
button.
Lrange
Here you can do the following:
• Set the range of the y-axis
• Select the default range
• Select a unit
To set the y-axis range:
1. Tap the Lrange button.
2. Enter the required value and tap the unit button.
The setting is accepted immediately and the input window is closed.
To select the unit:
1. Tap the Unit button.
The Unit dropdown menu opens.
Horizontal Scan
167
Advertisement
Table of Contents
