Setting Pre Average (Pre Avg.); Setting Pre Average / Switching It Off; Assigning Channel Bandwidth To Pre Average (Cbw -> Pre Avg.); Setting The Measurement Time (Meas. Time) - L3Harris Narda SignalShark User Manual

Setting pre average (Pre Avg.)

Setting pre average / switching it off

1. Tap the Pre Avg. button.
2. Enter the required value and tap the unit button.
The setting is accepted immediately and the input window is closed.
3. Set the value to zero to switch pre average off.
Assigning channel bandwidth to pre average (CBW –> Pre
Avg.):
Tap the CBW –> Pre Avg. button to switch it on.

Setting the measurement time (Meas. Time)

Here you can set the measurement time. The measurement or detector time defines the time
range used by the internal detectors to calculate their values (+Pk, RMS, -Pk, ...).
To set the measurement time:
You selected the desired view.
1. Tap the Meas. Time button.
2. Enter the required value and select a unit.
3. Press the Esc key twice to close the dialog and the menu.
Configuring the measurement performance
(Config)
Here you can define how measurements are performed.
You selected the desired view.
1. Tap the Config button.
2. Then you can do the following:

Setting the scan count number (Scan Count)

Sets the number of counted scans.
Changing the parameters:
1. Tap the button and set the number of scans either by using the rotary control knob or by
entering the value.
2. Tap the OK button.
3. Press the Esc key or tap the header to close the menu.
Level Meter View
97