Table of Contents
Advertisement
SignalShark User Manual
Setting the measurement frequency (Fcent /
Fspan, Fstart / Fstop)
Here you can set the measurement frequency.
Depending on the Entry Mode setting, the frequency can be entered in two modes:
• Entry Mode = Fcent: Define a center frequency and a frequency span.
• Entry Mode = Fstart: Define a start and stop frequency.
Selecting the measurement frequency
You selected the desired view.
1. Tap one of the two buttons Fcent / Fspan or Fstart / Fstop (display depends on the
current Entry Mode).
The context menu opens.
2. Tap the Entry Mode button to select Fcent or Fstart.
3. Press the Esc key to close the context menu.
If Entry Mode is set to Fcent
Setting the center frequency (Fcent)
1. Tap the Fcent button.
2. Enter the required value and select a unit.
The setting is accepted immediately and the dropdown list is closed.
Setting the frequency span (Fspan)
1. Tap the Fspan button.
2. Enter the required value and select a unit.
The setting is accepted immediately and the dropdown list is closed.
Setting the Auto Fcent trace
1. Tap the Auto Fcent Trace button.
2. Select the required value from the dropdown list and close the list using the x button.
Selecting the Auto Fcent function
Tap the Auto Fcent button.
Setting the step width (Fstep)
1. Tap the Fstep button.
2. Enter the required value and select a unit.
The setting is accepted immediately and the dropdown list is closed.
Selecting a transmitter table (Transmitter Tab.)
1. Tap the Transmitter Tab. button.
2. Select a transmitter table from the dropdown list and after confirming with OK the list is
closed.
80
Advertisement
Table of Contents
