Table of Contents
Advertisement
SignalShark User Manual
...Boarder
Here you can set the localization area by entering the coordinates. You can start from
scratch or first set the area to the selected map section (see Set_Localization_Area) and
then adapt the boarders to your needs.
To set the values:
1. Tap the desired Boarder button and turn the Rotary knob or enter a value.
2. Press the Rotary knob or tap the OK button.
Localize automatically (Auto Localize)
When Auto Localize is set to On, localization is calculated and displayed in the Map view
simultaneously with performing and recording the bearings. If set to Off, location must be
started manually after recording the bearings (see Start_localization_manually).
To switch Auto Localize on / off:
Tab the Auto Localize button to select the desired setting.
Start localization manually (Localize Now)
When Auto Localize is set to Off, localization can and must be started manually. For a
localization can be calculated, a record with bearings must be available.
To start localization manually:
1. In the Map view Main menu recall the record containing the stored bearings.
2. In the Localization menu tap the Localize Now button.
Localization is calculated and displayed as an ellipsis for the uncertainty region and a
cross that marks the potential location of the signal source.
3. Tap the Save Location button to save the location results.
The location results are stored to the Data Sets tab in the datalogger (see
data).
Changing general display settings (Display)
Here you can change general display settings such as showing the current position and
direction, changing the type of the bearing lines or showing the localization results.
To open the Display menu:
You selected the desired view.
1. Tap the Display button.
The Display menu opens.
2. You can now do the following:
Center
Tap to center your current position.
196
Managing
Advertisement
Table of Contents
