Connecting The Antenna To The Handle; Connecting Narda Directional Antennas; Connecting The Handle To The Device - L3Harris Narda SignalShark User Manual

Table of Contents

Advertisement

SignalShark User Manual

Connecting the antenna to the handle

Narda directional antennas can be attached to the handle in positions that are at angles of 90
degrees to each other. This makes it quick and easy for you to change the polarization plane
of the antenna.
Push the antenna onto the handle until you hear the connector click into place.
To remove the antenna, press in the two unlocking buttons and pull off the antenna.
The device automatically detects the connected antenna. Information about the detected
antenna is displayed in the
probably not configured. The configuration data of the antenna can be loaded into the
device using removable media (e. g. USB stick).

Connecting Narda Directional Antennas

Directional Narda antennas are connected to the device via the Narda antenna handle.
Full use of all the functions of the SignalShark is only possible when you use the Narda
antenna handle.
For information about connecting other than directional Narda antennas and non-Narda
antennas see
Connecting cables and antennas from other

Connecting the handle to the device

The antenna handle has a built-in cable with two connectors:
• Control connector: for power supply and for transmitting the compass data and control
signals
• N-connector: for transmitting the RF signal
Figure:
Control connector (1), N-connector (2)
To connect the handle:
1. Plug the control cable plug of the handle into the control connector socket on the device
(1), making sure that the red mark on the control cable plug is aligned with the notch on
the control connector socket (show figure
2. Press the control cable plug into the control connector socket using the locking sleeve
until the plug lock clicks into place.
3. Place the N-connector of the handle into the N-connector of the basic unit (2) and tighten
the coupling nut slowly and without tilting.
Make sure that the cable does not twist when you are tightening the coupling nut. The
40
system information
menu. If the antenna is not detected, it is
manufacturers.
).

Advertisement

Table of Contents
loading

Table of Contents