Recording Bearings; Configuring And Starting A Localization (Localization); Configuring Localization (Config Localization) - L3Harris Narda SignalShark User Manual

SignalShark User Manual
2. Press the Rotary knob or the OK key.

Recording bearings

For a localization bearings must be recorded. Based on the saved bearings a localization is
calculated and written to the same record. Records are saved in the datalogger and can be
recalled for later evaluation.
Prerequisites for recording bearings:
Set Select Data Sets to open record.
For only showing the bearings, set Data Type to Bearings
For showing the heatmap with localization, set Data Type to Localization
To create a new record:
1. Tap the New Record button.
2. Tap the Recording button to set it to On.
All bearings are now recorded and localization is automatically calculated if Auto Localize
is set to On (see Localization).
3. To stop recording tap the Recording button to set it to Off.
4. To clear map tap Close Record.
The record can be recalled from the datalogger.
To recall a record:
1. Tap the Recall Record button.
2. Select an entry from the dropdown menu and tap OK.
The record is loaded and displayed on the map.
Configuring and starting a localization
(Localization)
A localization is based on bearings. These bearings can be measured manually (e.g. by
using the antenna handle and a appropriate antenna) or automatically with the ADF antenna.
Depending on the Auto Localize setting the localization can be calculated automatically or
triggered manually. All settings needed for localization can be found in the Localization
menu.
To open the Localization menu:
Data Type is set to Localization.
In the Map view tap the Localization button.
The Localization menu opens.

Configuring localization (Config Localization)

In this menu you can set the following localization parameters:
Set Localization Area
To reduce the amount of localization calculations, the localization area must be specified.
194