Setting The Tuner Frequency (Ftune); Switching On / Off The Automatic Frequency Control (Afc); Switching On / Off Fcent <-> Ftune; Setting The Step Width (Fstep) - L3Harris Narda SignalShark User Manual

Setting the tuner frequency (Ftune)

You selected the desired view.
1. Tap the Ftune button.
2. Enter the required value and select a unit.
The settings is accepted immediately and the input window is closed.

Switching on / off the automatic frequency control (AFC)

Tap the AFC button to switch it on or off.
Switching on / off Fcent <–> Ftune
Tap the Fcent <–> Ftune button to switch it on or off

Setting the step width (Fstep)

1. Tap the Fstep button.
2. Enter the step width and select a unit.
The settings are accepted immediately and the input window is closed.

Selecting a Transmitter Table (Transmitter Tab.)

1. Tap the Transmitter Table button.
2. Select a table from the dropdown window and confirm with OK.
For more information about how to create a transmitter table see

Selecting the mode of the rotary wheel (Rotary Mode)

You can select following modes:
• Digit / Fstep: changes Ftune by digits or the selected Fstep
• Fast Tune: changes Ftune by rotating the wheel dynamically (rotating the wheel long and
fast accelerates the change)
• Transmitter: changes Ftune by selecting a transmitter from the transmitter table
1. Tap the Rotary Mode button.
2. Select a mode from the dropdown window and close the window using the X button.
Setting the channel / EMC bandwidth
(CBW / EBW)
Here you can do the following:
1. Select the current filter type CBW or EBW (CISPR, MIL-STD-461-F).
2. Set the channel bandwidth (CBW) or EMC bandwidth (EBW).
3. Select Oversampling.
Bearing View
Transmitter Tables.
151