Changing General Display Settings (Display); Lmax; Lrange - L3Harris Narda SignalShark User Manual

To select the Third Detector:
1. Tap the Third Detector button.
2. Select a detector from the dropdown list.
3. Press the Esc key twice to close the dropdown list and the menu.
Visible Detector
The Visible Detector is the detector that is displayed in the diagram.
To select the Visible Detector:
1. Tap the Visible Detector button.
2. Select a detector from the dropdown list (only the enabled detectors are shown in the
dropdown list).
3. Press the Esc key twice to close the dropdown list.

Changing general display settings (Display)

Here you can change general display settings such as the zero point of the Y-axis, the range
of the Y-axis or the axis unit (the available settings depend on the current view).
To open the Display menu:
You selected the desired view.
1. Tap the Display button.
The Display menu opens.
2. You can now do the following:

Lmax

Here you can do the following:
• Set the maximum power level of the graph
• Set the Ref.L. -> Lmax function On or Off
• Set the Couple Views function On or Off
• Select Default Range or Auto Range
• Select the Unit
To set the maximum power level:
1. Tap the Lmax button.
2. Enter the required value and tap the unit button.
The setting is accepted immediately and the input window is closed.
3. Press the Esc key to close the menu.
To select the Unit:
1. Tap the Unit button.
The Unit dropdown menu opens.
2. Select one of the units (dBm, dBV, dBmV, dBuV) and close the menu by tapping the x
button.

Lrange

Here you can do the following:
Spectrogram View
129