External Connections; Ethernet Connections - Waters ACQUITY UPLC H-Class Series System Manual

5

External connections

See also:
For information explaining how to connect chromatographic tubing, see
recommendations for
Note:
A Waters Technical Service representative unpacks and installs the system components.
Warning:
without assistance.
If you must transport a system component, or remove it from service, request recommended
cleaning, flushing, and packaging procedures from Waters Technical Service.

5.1 Ethernet connections

The sample manager incorporates an internal Ethernet switch that accommodates the PC
(workstation) and as many as six system modules. Connect the shielded Ethernet cables from
each module to the electronic connections on the rear panel of the sample manager. The sample
manager is connected internally to the Ethernet switch.
fittings.
To avoid spinal and muscular injury, do not attempt to lift a system module
April 4, 2018, 715005702 Rev. A
Page 69
Installation