Waters ACQUITY UPLC H-Class Series System Manual page 92

Warning:
To avoid crushing your fingers beneath or between modules, use extreme
care when installing a module in the system stack.
To stack the modules:
1. Align the front and rear feet of the module that you are adding with the corresponding
indents in the top of the chassis of the previously added module in the system stack.
Figure B–2: Aligning feet with indents
Feet on underside of module being stacked
Indents on top side of previously added module
2. Carefully lower the module so that the feet rest in the indents.
Important:
To maintain the integrity of the system stack and integrated waste system,
ensure that the feet of the upper module rest in the indents of the lower module.
3. Repeat steps 1 and 2 for the remaining system modules.
April 4, 2018, 715005702 Rev. A
Page 92