Table of Contents
Advertisement
To enable the leak sensors:
1.
In the ACQUITY UPLC Console, select Control > Leak Sensors.
2.
To enable the leak sensor for an individual module, click the status on the left-hand side of
the module's description.
Tip:
To enable all leak sensors, click Enable All.
3.6 Monitoring from control panels
You can monitor the sample manager, solvent manager, column module, detector, and fraction
manager from control panels, which you access via the chromatography data system.
• When Empower software controls the system, the control panels appear at the bottom of the
Run Samples window.
• When MassLynx software controls the system, the control panels appear on the Additional
Status tab of the Inlet Editor window.
• When UNIFI software controls the system, the control panels appear in the right-hand utility
pane of the main window whenever a system is selected for the System Console or data
analysis activities.
You can update a parameter set point directly from a control panel, providing sample analysis is
not running. When the parameter value is underscored and appears in blue, sample analysis is
not running, and you can click the parameter value and specify a new value in the dialog box that
appears.
3.6.1 Column manager control panel
The column manager's control panel displays the current column temperature and set point of the
column manger auxiliary (CM-AUX). Other compatible column modules are controlled via the
sample manager control panel.
If Empower software controls the system, the column manager's control panel appears at the
bottom of the Run Samples window. If MassLynx software controls the system, the control panel
appears on the Additional Status tab of the Inlet Editor window.
You can edit the set point when the system is idle by clicking on the underlined value. You cannot
edit temperature set point and column selection while the system is running samples.
April 4, 2018, 715005702 Rev. A
Page 52
Hide quick links:
Advertisement
Table of Contents
