Automatic logout after timeout
After 600 seconds without saving or changing the WBM page, you are logged out and
disconnected from the WBM. In this case, you must log in again.
In the WBM toolbar you can see the counter in the upper right-hand corner which displays
the remaining time of the current session. By clicking the time display, the counter of the
session duration is reset and the time of the session duration starts all over again.
The page provides an overview of important status and configuration data of the device.
● Operating state
Operating state of the device
● System runtime (dd-hh-mm-ss)
Time since the last startup (dd-hh-mm-ss)
● Hardware product version
Hardware product version of the device
● U-Boot version
Current U-Boot version for the firmware bootloader
● Software version
Current firmware version of the device
● Serial number
Serial number of the device
The parameter group displays the current address data of the P2 interface.
● MAC address
Address parameters, Default router
Operating Instructions, 05/2019, C79000-G8976-C503-01
4.5 Start page