4.6 Interface configuration
The parameter group displays the current address data of the P1 interface.
● MAC address
● IPv4 / IPv6
Address parameters, Default router
The parameter group shows the IPv4 addresses of up to two configured DNS servers.
In this tab, you configure the address data of the Ethernet interfaces of the device.
Interface and factory default addresses
You configure the following interfaces on the web pages:
● Process interface (P2)
The interface (P2) is used for connecting to the subnet of the process stations.
● Cloud interface (P1)
The interface (P1) is used for connecting to the Internet or to a router over which the
broker or the network with OPC UA clients can be reached.
The device supports IPv4 addresses, and for cloud access also IPv6 addresses.
The following address data is preset in the factory:
Table 4- 2
Preset address data
Process interface (P2)
Address data preset in the factory
Cloud interface (P1)
Operating Instructions, 05/2019, C79000-G8976-C503-01