Clp Slot - Siemens SIMATIC CC712 Operating Instructions Manual

LEDs, Connectors, Buttons, CLP

2.4 CLP Slot

Pressing the button
Duration of pressing Function and operation
the button (seonds)
≥ 5 s Resetting to factory settings
1. Turn off the power supply.
2. Switch the power supply on again while pressing the button.
3. Release the button when the LED stops flashing.
Once reset is complete, the gateway performs a restart and can be reached using the default IP
address set at the factory.
2.4 CLP Slot
The slot for an optional CLP is located on the back of the module.
For information on inserting and removing the CLP, see section Using a CLP (Page 35).
Figure 2-2
24
Hold down the button for at least 5 seconds during startup.
Reset is prepared while the "Diagnosis" LED flashes.
While the LED lights up with a green steady light, the gateway performs the reset.
Slot for optional CLP on the back of the device
Operating Instructions, 05/2019, C79000-G8976-C503-01
SIMATIC CC712