Siemens SIMATIC CC712 Operating Instructions Manual page 104

Approvals
IECEx
The product meets the requirements of explosion protection according to IECEx.
IECEx classification:
Ex ec IIC T4 Gc
Certificate: IECEx DEK 18.00xxX
Applied standards:
● EN 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
● EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety
'e'
You can see the current versions of the standards in the IECEx certificate that you will find
on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/25621/cert)
Note the conditions for the safe deployment of the product according to the section Notes on
use in hazardous areas according to ATEX / IECEx (Page 26).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
ATEX
The product meets the requirements of the EC directive:2014/34/EC "Equipment and
Protective Devices for Use in Potentially Explosive Atmospheres".
ATEX approval:
II 3 G Ex ec IIC T4 Gc
Type Examination Certificate: DEKRA 18ATEX00xxX
Applied standards:
● EN 60079-0 - Explosive atmospheres - Part 0: Equipment - General requirements
● EN 60079-7 - Explosive Atmospheres - Part 7: Equipment protection by increased safety
'e'
The current versions of the standards can be seen in the EC Declaration of Conformity, see
above.
The conditions must be met for the safe deployment of the product according to the section
Notes on use in hazardous areas according to ATEX / IECEx (Page 26).
You should also note the information in the document "Use of subassemblies/modules in a
Zone 2 Hazardous Area" that you will find on the Internet at the following address:
Link: (https://support.industry.siemens.com/cs/ww/en/view/78381013)
104
Operating Instructions, 05/2019, C79000-G8976-C503-01
SIMATIC CC712