IBM Power Systems 775 Manual page 201

rscan
For this command, we list the help description in Figure 3-8. A typical output example is
shown in Example 3-23.
# rscan -h
Usage: rscan <noderange> [-u][-w][-x|-z] [-V|--verbose]
rscan [-h|--help|-v|--version]
Figure 3-8 rscan command flag description
The rscan command collects node information from one or more hardware control points. The
following input and output values are used:
Command: rscan <noderange>
Flags:
– -z: Converts the output into xCAT "stanza" format.
Outputs:
[no-flags]
type name id type-model serial-number side address
<type> <name> <id> <type-model> <serial-number> <side> <address>
Attributes:
– <noderange>: Nodes that are listed in xCAT database that belong to an FSP hardware
type.
– <name>: Device name type that is scanned.
– <id>: ID for LPAR of the device that is scanned.
– <type-model>: XXXX-YYY model type.
– <serial-number>: IBM 7-hexadecimal serial number. The serial number associates all
the LPARs belonging to a determined FSP.
– <side>: [A | B].
– <address>: IP for the hardware component.
Example 3-23 rscan output example
# rscan fsp
type name id
fsp 40.10.12.1
lpar 02d76951 1
lpar 02d76952 2
lpar 02d76955 5
lpar 02d76959 9
lpar 02d769513 13
lpar 02d769517 17
lpar 02d769518 18
lpar 02d769521 21
lpar 02d769525 25
lpar 02d769529 29
lsvm
For this command, we list the help description that is shown in Figure 3-9 on page 188. A
typical output example is shown in Example 3-24 on page 189.
type-model serial-number side
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
9125-F2C 02D7695
address
A 40.10.12.1;
Chapter 3. Monitoring assets
187