Example 3-10 mmlsvdisk output example with recovery group (one declustered array)
# mmlsvdisk --recovery-group 000DE22TOP --declustered-array DA1
vdisk:
name = "000DE22TOPDA1META"
raidCode = "4WayReplication"
recoveryGroup = "000DE22TOP"
declusteredArray = "DA1"
blockSizeInKib = 2048
size = "1000 GiB"
state = "ok"
remarks = ""
vdisk:
name = "000DE22TOPDA1DATA"
raidCode = "8+3p"
recoveryGroup = "000DE22TOP"
declusteredArray = "DA1"
blockSizeInKib = 16384
size = "6143 GiB"
state = "ok"
remarks = ""
mmgetpdisktopology
For this command, there is no help description, arguments, or flags. A typical usage example
is shown in Example 3-11.
The mmgetpdisktopology command gathers information about all of the connected DEs to the
LPAR where the command is executed. The command generates the following input and
output values:
Command: mmgetpdisktopology
Flags: None
Outputs: See Example B-1 on page 324.
Important: The contents for the file "/mmgetpdisktopology_file.output" in Example 3-11
are summarized in Example B-1 on page 324.
Example 3-11 mmgetpdisktopology usage example
# mmgetpdisktopology > /mmgetpdisktopology_file.output
topsummary
For this command, there is no help description or flags. The command takes only a file as an
input or stdin (standard input). A typical output example is shown in Example 3-12 on
page 175.
The topsummary command compiles all of the information from the mmgetpdisktopology
command and generates a readable output. The command generates the following input and
output values:
Command: topsummary <stdin_or_file>
Flags: NONE
Outputs:
174
IBM Power Systems 775 for AIX and Linux HPC Solution
Need help?
Do you have a question about the Power Systems 775 and is the answer not in the manual?