Danfoss FC 300 Programming Manual page 90

2. How to Programme
2
4-32 Motor Feedback Loss Timeout
Range:
0.05 s
2.7.4. 4-5* Adjustable Warnings
Define adjustable warning limits for current, speed, reference and feedback. Warnings are shown
on the display, programmed output or serial bus.
Warnings are shown on display, programmed output or serial bus.
4-50 Warning Current Low
Range:
0.00 A
90
Function:
*
[0.00 - 60.00 sec] Set the timeout value allowing the speed error set in par. 4-31
to be exceeded.
Function:
*
[0.00 - par. 4-51] Enter the I
limit, the display reads
programmed to produce a status signal on terminal 27 or 29 and
on relay output 01 or 02. Refer to the drawing in this section.
MG.33.M2.02 - VLT
value. When the motor current falls below this
LOW
Current Low
. The signal outputs can be
®
is a registered Danfoss trademark
FC 300 Programming Guide