Parameters: Load And Motor - Danfoss FC 300 Programming Manual

2. How to Programme
0-66 Access to Quick Menu w/o Password
2
Option:
[0]
[1]
[2]
[3]
[4]
[5]
[6]
If par. 0-61
be ignored.
0-67 Bus Password Access
Range:
*
0

2.4. Parameters: Load and Motor

2.4.1. 1-0* General Settings
Define whether the frequency converter operates in speed mode or torque mode; and whether
the internal PID control should be active or not.
1-00 Configuration Mode
Option:
[0]
[1]
42
* Full access
Read only
No access
Bus: Read only
Bus: No access
All: Read only
All: No access
Access to Main Menu w/o Password
[0 - 9999]
Speed open loop
Speed closed loop
MG.33.M2.02 - VLT
Full access
set to [0], this parameter will be ignored.
Function:
Disables the password defined in par. 0-65
word
.
Prevents unauthorised editing of Quick Menu parameters.
Prevents unauthorised viewing and editing of Quick Menu pa-
rameters.
Read only functions for parameters on fieldbus and/ or FC
standard bus.
No access to parameters is allowed via fieldbus and/ or FC
standard bus.
read only function for parameters on LCP, fieldbus or FC stand-
ard bus.
No access from LCP, fieldbus or FC standard bus is allowed.
Full access
is set to
Function:
Writing to this parameter enables users to unlock the drive from
bus/ MCT10
Function:
Select the application control principle to be used when a Re-
mote Reference (i.e. via analog input or fieldbus) is active. A
Remote Reference can only be active when par. 3-13
Site
is set to [0] or [1].
Enables speed control (without feedback signal from motor)
with automatic slip compensation for almost constant speed at
varying loads.
Compensations are active but can be disabled in the Load/Motor
par. group 1-0*.
Enables encoder feedback from motor. Obtain full holding tor-
que at 0 RPM.
®
is a registered Danfoss trademark
FC 300 Programming Guide
Quick Menu Pass-
[0] then this parameter will
Reference