Danfoss FC 300 Programming Manual page 18

2. How to Programme
Parameter
0-01
1-20
1-22
2
1-23
1-24
1-25
5-12
1-29
3-02
3-03
3-41
3-42
3-13
* If terminal 27 is set to "no function", no connection to +24 V on terminal 27 is necessary.
Select
about:
•
•
18
Designation
Language
Motor Power
Motor Voltage
Motor Frequency
Motor Current
Motor Nominal Speed
Terminal 27 Digital Input
Automatic Motor Adaptation (AMA)
Min Reference
Max Reference
Ramp 1 Ramp-up Time
Ramp 1 Ramp-down Time
Reference Site
Changes made
to get information
the last 10 changes. Use the [▴] [▾]
navigation keys to scroll between the
last 10 changed parameters.
the changes made since default set-
ting.
MG.33.M2.02 - VLT
Setting
[kW]
[V]
[Hz]
[A]
[rpm]
[0] No function*
[1] Enable complete AMA
[rpm]
[rpm]
[sec]
[sec]
Loggings
Select to get information about the
display line read-outs. The information is
shown as graphs.
Only display parameters selected in par. 0-20
and par. 0-24 can be viewed. It is possible to
store up to 120 samples in the memory for
later reference.
®
is a registered Danfoss trademark
FC 300 Programming Guide