Danfoss FC 300 Programming Manual page 152

2. How to Programme
10-30 Array Index
Range:
*
0
2
10-31 Store Data Values
Option:
[0]
[1]
[2]
10-32 Devicenet Revision
Option:
10-33 Store Always
Option:
[0]
[1]
10-39 Devicenet F Parameters
Array [1000]
No LCP access
*
0
152
[0 - 255]
Read only from LCP.
* Off
Store edit setup
Store all setups
Major revision
Minor revision
* Off
On
[0 - 0]
MG.33.M2.02 - VLT
Function:
View array parameters. This parameter is valid only when a De-
viceNet fieldbus is installed.
Function:
Parameter values changed via DeviceNet are not automatically
stored in non-volatile memory. Use this parameter to activate a
function that stores parameter values in the EEPROM non-vol-
atile memory, so changed parameter values will be retained at
power-down.
Deactivates the non-volatile storage function.
Stores all parameter values from the active set-up in the non-
volatile memory. The selection returns to Off [0] when all values
have been stored.
store all parameter values for all set-ups in the non-volatile
memory. The selection returns to
values have been stored.
Function:
View the DeviceNet revision number. This parameter is used for
EDS file creation.
Function:
Deactivates non-volatile storage of data.
Stores parameter data received via DeviceNet in EEPROM non-
volatile memory as default.
This parameter is used to configure the frequency converter via
DeviceNet and build the EDS-file.
®
is a registered Danfoss trademark
FC 300 Programming Guide
Off
[0] when all parameter