Danfoss FC 300 Programming Manual page 130

2. How to Programme
2.11.3. 8-1* Ctrl. Word Settings
2
Parameters for configuring the option control word profile.
8-10 Control Word Profile
Option:
[0]
[1]
[5]
[7]
8-13 Configurable Status Word STW
Option:
[0]
[1]
[2]
[3]
[16]
2.11.4. 8-3* FC Port Settings
Parameters for configuring the FC Port.
8-30 Protocol
Option:
[0]
[1]
130
* FC profile
PROFIdrive profile
ODVA
CANopen DSP 402
No function
*
Profile default
Alarm 68 only
Trip except Alarm 68 Set in case of a trip, except if the trip is executed by an Alarm
T37 DI status
* FC
FC MC
MG.33.M2.02 - VLT
Enabling diagnosis may cause increased bus traffic. Diagnosis
functions are not supported by all fieldbus types.
Function:
Select the interpretation of the control and status words corre-
sponding to the installed fieldbus. Only the selections valid for
the fieldbus installed in slot A will be visible in the LCP display.
For guidelines in selection of
file [1] please refer to the
Interface
section.
For additional guidelines in the selection of
ODVA CANopen DSP 402
[1], [5] and
Operating Instructions for the installed fieldbus.
Function:
This parameter enables configuration of bit 12 – 15 in the status
word.
Function corresponds to the profile default selected in par. 8-10.
Only set in case of an Alarm 68.
68.
The bit indicates the status of terminal 37.
"0" indicates T37 is low (safe stop)
"1" indicates T37 is high (normal)
Function:
Select the protocol for the FC (standard) port.
®
is a registered Danfoss trademark
FC 300 Programming Guide
FC profile PROFIdrive pro-
[0] and
Serial communication via RS 485
PROFIdrive profile
[7], please refer to the