Danfoss FC 300 Programming Manual page 161

FC 300 Programming Guide
[126]
[127]
[130]
[131]
[132]
[133]
[134]
[135]
[150]
[151]
[152]
[153]
[154]
[155]
[160]
[161]
[180]
[181]
[182]
[183]
[185]
[186]
13-11 Comparator Operator
Array [6]
[0]
SL Time-out 6
SL Time-out 6
SL Time-out 7
SL Time-out 7
Digital input DI18
Digital input DI18
Digital input DI19 Digital input DI19
Digital input DI27
Digital input DI27
Digital input DI29
Digital input DI29
Digital input DI32
Digital input DI32
Digital input DI33
Digital input DI33
SL digital output A
SL digital output A
SL digital output B
SL digital output B
SL digital output C SL digital output C
SL digital output D SL digital output D
SL digital output E
SL digital output E
SL digital output F
SL digital output F
Relay 1
Relay 1
Relay 2
Relay 2
Local ref. active
Local ref. active
[2] Local or when par 3-13 is [0] Linked to hand Auto, at the
same time as the LCP is in Hand on mode.
Remote ref. active
Remote ref. active
= [1] Remote or [0] Linked to hand/auto, while the LCP is in
Auto on mode.
Start command
Start command
mand, and no stop command.
Drive stopped
Drive stopped
is issued – and not from the SLC itself.
Drive in hand mode
Drive in hand mode
Drive in auto mode
Drive in auto mode
For par. 13-10 containing values from [0] to [31] the following
is valid:
Select the operator to be used in the comparison.
< Select
the variable selected in par. 13-10 is smaller than the fixed value
in par. 13-12. The result will be FALSE, if the variable selected
in par. 13-10 is greater than the fixed value in par. 13-12.
®
MG.33.M2.02 - VLT is a registered Danfoss trademark
[126] The result of SLC timer 6.
[127] The result of SLC timer 7.
[130] Digital input 18. High = True.
[131] Digital input 19. High = True.
[132] Digital input 27. High = True.
[133] Digital input 29. High = True.
[134] Digital input 32. High = True.
[135] Digital input 33. High = True.
[150] Use the result of the SLC output A.
[151] Use the result of the SLC output B.
[152] Use the result of the SLC output C.
[153] Use the result of the SLC output D.
[154] Use the result of the SLC output E.
[155] Use the result of the SLC output F.
[160] Relay 1 is active
[161] Relay 2 is active
[180] High when par. 3-13 "Reference site" =
[181] High when par. 3-13 "Reference site"
[182] High when there is an active start com-
[183] A stop command ( Jog, Stop, Qstop, Coast)
[185] High when the drive is in hand mode.
[186] High when the drive is in auto mode.
< [0] for the result of the evaluation to be TRUE, when
2. How to Programme
161
2