Danfoss FC 300 Programming Manual page 34

2. How to Programme
[1650] External Reference
[1651] Pulse Reference
2
[1652] Feedback [Unit]
[1653] Digi Pot Reference
[1660] Digital Input
[1661] Terminal 53 Switch
[1662] Analog Input 53
[1663] Terminal 54 Switch
[1664] Analog Input 54
[1665] Analog
[1666] Digital Output [bin]
[1667] Freq. Input #29 [Hz] Actual value of the frequency applied at terminal 29 as an im-
[1668] Freq. Input #33 [Hz] Actual value of the frequency applied at terminal 33 as an im-
[1669] Pulse
[1670] Pulse
[1671] Relay Output [bin]
[1672] Counter A
[1673] Counter B
[1674] Prec. Stop Counter
[1680] Fieldbus CTW 1
[1682] Fieldbus REF 1
[1684] Comm. Option STW
[1685] FC Port CTW 1
[1686] FC Port REF 1
[1690] Alarm Word
[1691] Alarm Word 2
[1692] Warning Word
[1693] Warning Word 2
34
Sum of the external reference as a percentage, i.e. the sum of
analog/pulse/bus.
Frequency in Hz connected to the digital inputs (18, 19 or 32,
33).
Reference value from programmed digital input(s).
Signal states form the 6 digital terminals (18, 19, 27, 29, 32 and
33). Input 18 corresponds to the bit at the far left. Signal low =
0; Signal high = 1.
Setting of input terminal 54. Current = 0; Voltage = 1.
Setting
Actual value at input 53 either as a reference or protection val-
ue.
Setting of input terminal 54. Current = 0; Voltage = 1.
Setting
Actual value at input 54 either as reference or protection value.
Output 42 Actual value at output 42 in mA. Use par. 6-50 to select the value
[mA] to be shown.
Binary value of all digital outputs.
pulse input.
pulse input.
Output #27 Actual value of impulses applied to terminal 27 in digital output
[Hz] mode.
Output #29 Actual value of impulses applied to terminal 29 in digital output
[Hz] mode.
Control word (CTW) received from the Bus Master.
Main reference value sent with control word from the Bus Mas-
ter.
Extended fieldbus communication option status word.
Control word (CTW) received from the Bus Master.
Status word (STW) sent to the Bus Master.
One or more alarms in a Hex code.
One or more alarms in a Hex code.
One or more warnings in a Hex code.
One or more warnings in a Hex code.
MG.33.M2.02 - VLT
®
is a registered Danfoss trademark
FC 300 Programming Guide