Danfoss FC 300 Programming Manual page 45

FC 300 Programming Guide
Motor construction can either be asynchronous or permanent magnet (PM) motor.
2.4.3. 1-2* Motor Data
Parameter group 1-2* comprises input data from the nameplate on the connected motor.
Parameters in parameter group 1-2* cannot be adjusted while the motor is running.
1-20 Motor Power
Range:
Size re-
lated
1-21 Motor Power [HP]
Range:
Size re-
lated
1-22 Motor Voltage
Range:
Size re-
lated
1-23 Motor Frequency
Option:
[50]
Note that PM motors are divided into two groups, with either
surface mounted (non salient) or interior (salient) magnets.
NB!
Changing the value of these parameters affects the setting of other parameters.
Function:
[0.09 - 1200 kW] Enter the nominal motor power in kW according to the motor
* nameplate data. The default value corresponds to the nominal
rated output of the unit.
This parameter cannot be adjusted while the motor is running.
This parameter is visible in LCP if par. 0-03 is
Function:
[0.09 - 500 HP] Enter the nominal motor power in HP according to the motor
*
nameplate data. The default value corresponds to the nominal
rated output of the unit. This parameter is visible in LCP if par.
0-03 is
Function:
[10 - 1000 V] Enter the nominal motor voltage according to the motor name-
* plate data. The default value corresponds to the nominal rated
output of the unit.
Function:
Min - Max motor frequency: 20 - 1000 Hz.
Select the motor frequency value from the motor nameplate
data. If a value different from 50 Hz or 60 Hz is selected, it is
necessary to adapt the load independent settings in par. 1-50
to 1-53. For 87 Hz operation with 230/400 V motors, set the
nameplate data for 230 V/50 Hz. Adapt par. 4-13
High Limit [RPM)
Hz application.
* 50 Hz when parame-
ter 0-03 = interna-
tional
®
MG.33.M2.02 - VLT is a registered Danfoss trademark
US
[1]
Maximum Reference
and par. 3-03
2. How to Programme
International
[0].
Motor Speed
to the 87
45
2