Using the Logic Analyzer
To access the Scope menus
To access the Scope menus
The Scope menus allow you to control the analyzer to make your
measurement, perform operations on the data, and view the results on the
display.
Select the mode field.
1
A pop-up menu appears with the choices System, Analyzer, and Scope. (If
you have installed any optional software, there may be other choices as well.)
Select Scope.
2
Select the menu field.
3
The pop-up lists six menus: Scope Channel, Scope Display, Scope Trigger,
Scope Marker, Scope Auto Measure, and Scope Calibration.
•
Scope Channel lets you select the channel input. It lets you set values that
control the vertical sensitivity, offset, probe attenuation factor, input
impedance, and coupling of the input channel currently shown in the Input
field. The Channel menu also gives you preset vertical sensitivity, offset,
and trigger level values for ECL and TTL logic levels.
•
Scope Display controls how the oscilloscope acquires and displays
waveforms. You can acquire and display the waveforms in one of the
following modes: Normal, Average, or Accumulate. The Display options
also control the connect-the-dots display and grid display features.
3–8