To View Trace Lists And Waveforms On The Same Display - HP 1660CS-Series User Manual

Special displays

To view trace lists and waveforms on the same display

To view trace lists and waveforms on the same display
Set up a timing and a state analyzer, or a state analyzer and the
1
oscilloscope.
Go to the state analyzer's Trigger menu.
2
Set Count to Time, and set up the trigger as appropriate.
3
You do not need to have one instrument arming the other to display the
information jointly, but you do need to turn on Count Time so that the
information may be correlated.
Set up the timing analyzer trigger, if you are using the timing analyzer.
4
Timing analyzers implicitly count time because their sampling is driven by an
internal clock, rather than an external state clock.
Set the oscilloscope mode to Immediate, if you are using the
5
oscilloscope.
Make a measurement run.
6
Go to the Mixed Display menu.
7
To insert state listings, select any label field from the state listing.
8
From the pop-up that appears, select the desired label to insert.
You cannot view timing data in the listing area.
To insert timing or oscilloscope waveforms, double-select the label
9
field to the left of the waveform display area. From the pop-up that
appears, select insert, and then the appropriate label.
You cannot view state analyzer data in the waveform display. However, you
can view timing analyzer data and oscilloscope data simultaneously.
You can also position X and O Time markers on the waveform display. Once
set, the time markers will be displayed in both the listing and the waveform
display areas. Note that even if you set X and O Time markers in another
display, you must also set the Time markers in the Mixed Display if Time
markers are desired.
You can use the Mixed Display feature in the analyzer menu to show both
waveforms and trace lists in the same display, making it easier to correlate the
events of interest.
5-32