Keysight N437 Series Programmer's Manual page 56

1 Remote Operation
56
Command :PARameter:OPTical:S2PFile:USE
Syntax :PARameter:OPTical:S2PFile:USE<wsp>ON|1|OFF|0
Description enables or disables description of the optical paths by transmission data
stored in an s2p file. Only the S21 transmission data is used
Parameters <string> ON | 1 = s2p file use enabled, OFF | 0 = disabled
Response none
C# (property) UseIOpticalS2PFile
Example :PAR:OPT:S2PF:USE ON
Command :PARameter:OPTical:SOURce:S2PFile?
Syntax :PARameter:OPTical:SOURce:S2PFile?
Description Retrieves the name of the s2p file to use for additional adaptor de-
embedding on the source side. In default mode only evaluated for O/E and
O/O measurements.
Parameters none
Response <string> file name and path of the s2p file on the LCA system.
C# (property) OptSrcFile
Example :PAR:OPT:SOUR:S2PF? -> c:\temp\test1.s2p
Command :PARameter:OPTical:SOURce:S2PFile
Syntax :PARameter:OPTical:SOURce:S2PFile<wsp>"<path
Description Specifies the name of the s2p file to use for additional adaptor
de-embedding on the source side. In default mode only evaluated for O/E
and O/O measurements.
Parameters "<string>" the file name and path enclosed in double quotes.
Response <string> file name and path of the s2p file on the LCA system.
C# (property) OptSrcFile
Example :PAR:OPT:SOUR:S2PF "c:\temp\test1.s2p"
Keysight N437x Series Lightwave Component Analyzer, Programmer's Guide
string>"